CrazyInside Posted April 26, 2020 Share Posted April 26, 2020 Just wanted to thank @Micah Had a Nero 5 pump take out one of my onyx clowns in a new softie tank I setup and he 3D printed me some guards. Work great! 7 Quote Link to comment Share on other sites More sharing options...
Micah Posted April 26, 2020 Share Posted April 26, 2020 Aww, thanks man. Quote Link to comment Share on other sites More sharing options...
Danik Posted April 26, 2020 Share Posted April 26, 2020 Dang Micah those looks sweet, good job. I might need a coupe too.... 😉 1 Quote Link to comment Share on other sites More sharing options...
CuttleFishandCoral Posted April 26, 2020 Share Posted April 26, 2020 Micah made me two of these as well. The forum is blessed to have Micah back on it. 1 Quote Link to comment Share on other sites More sharing options...
TaylorW Posted April 26, 2020 Share Posted April 26, 2020 That's so nice of you! I think you also made the skimmer stand for someone right? Sent from my moto g(7) using Tapatalk Quote Link to comment Share on other sites More sharing options...
reefnjunkie Posted April 26, 2020 Share Posted April 26, 2020 15 hours ago, CrazyInside said: Just wanted to thank @Micah Had a Nero 5 pump take out one of my onyx clowns in a new softie tank I setup and he 3D printed me some guards. Work great! Nice I was looking online for 3D programs he could use to make me some for the QD40s but I never found any that looked OK Nice job Micah!! Quote Link to comment Share on other sites More sharing options...
TaylorW Posted April 27, 2020 Share Posted April 27, 2020 I would love one for the wavemaker in my 50 but it's not a super common pump unfortunately, it's a Uniclife 2100. I really like it and I've been using some mesh cut from an old black mesh media bag to cover the pump so none of my critters get chopped up, it works but I have to clean it every couple days so it would be great to have a nem guard for it. I'd pay someone to make me one but I don't know squat about 3D printing so I don't know how difficult it would be to make one lolSent from my moto g(7) using Tapatalk Quote Link to comment Share on other sites More sharing options...
Micah Posted April 27, 2020 Share Posted April 27, 2020 If anybody can message me with the dimensions of such pumps, I can give it a shot. It'll cost more in the long run if I can't hold the pump in my hand though. Being able to measure with calipers and test fit on the actual pump/part allows for pretty rapid prototyping.. So, if you can get me the thing you're actually trying to fit, I can make pretty much anything. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.