Jump to content

Wish me luck


Recommended Posts

The key is to make clean, straight cuts on the aluminum frame.  I used a metal blade on my jigsaw, and used a 90 degree guide clamp to ensure the cuts were square.  Then a metal file to brush off any burrs.

After assembling the frame, lay the netting over it and bind it in place with the rubber tubing, then cut it to size with a razor knife after it's all installed.  That's much easier than trying to attach the netting already cut to size.

Good luck!

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...