wanareef Posted January 25, 2009 Share Posted January 25, 2009 Just finished this today , my take on the frag rack. I am using nickel plated DXO2's on the inside and found out that using two of these would not work, so using DXO6's on the outside. The PVC caps are 3/4" and I cut a "spacer" of 3/4" PVC to fill the inside of the cap and allow the 1/8" thick DXO2 to fit or the DXO6 3/8" to fit and close off the opening with a piece of 1/8" acrylic. I used #16. On the next rack, I'll just use the DXO6's as there are stronger, thicker but cost more and are on sale 20% off - don't know how long On the outside shot, the left cap has not been trimmed off yet, that's why the rectangular "foot". Next one will be little larger and wider and will need 3 (6) magnets instead of 2 (4) Quote Link to comment Share on other sites More sharing options...
CA2OR Posted January 25, 2009 Share Posted January 25, 2009 that is sweet. Good job. Quote Link to comment Share on other sites More sharing options...
workaholic Posted February 1, 2009 Share Posted February 1, 2009 Nice job, where did you get the magnets? Tom Quote Link to comment Share on other sites More sharing options...
MadReefer Posted February 1, 2009 Share Posted February 1, 2009 http://www.kjmagnetics.com/products.asp?cat=10 Quote Link to comment Share on other sites More sharing options...
workaholic Posted February 1, 2009 Share Posted February 1, 2009 Thanks for the link. Tom Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.