Frank Posted May 24, 2008 Share Posted May 24, 2008 Does any one have one of theses is so how do you cal. it in (flame).... Im going nuts trying to get this (nutty).... Quote Link to comment Share on other sites More sharing options...
spectra Posted May 24, 2008 Share Posted May 24, 2008 What do the 2 set points say on them? I just set up a cheaper pinpoint meter this evening and it was simple. Just put the probe in the solution and turn the adjuster until it read what solution you were in. Good luck. Quote Link to comment Share on other sites More sharing options...
Frank Posted May 24, 2008 Author Share Posted May 24, 2008 I wish it was that easy... This has a cal and slope and I can get it to read the 7.01 but it wont read the 10.01 if I get it to it wont go low enough to read the 7.01 going crazy.... Quote Link to comment Share on other sites More sharing options...
spectra Posted May 24, 2008 Share Posted May 24, 2008 There has to be an easy way. Was this used when you got it? Any destructions with it? Quote Link to comment Share on other sites More sharing options...
Frank Posted May 24, 2008 Author Share Posted May 24, 2008 Yea ut was used but I know it works.. I got anew probe and now I have cal it.... It just has to many dam adjustments... The Instructions suck... Quote Link to comment Share on other sites More sharing options...
spectra Posted May 24, 2008 Share Posted May 24, 2008 Ever figure it out? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.