psychofireman Posted January 28, 2021 Share Posted January 28, 2021 I’m sure people have had this issue. Since this is my 2nd trident and they both have had same issue. Has anyone else had the input and output water lines leak where the hook up to the disk thingy? If so how did you fix it? Quote Link to comment Share on other sites More sharing options...
SuncrestReef Posted January 28, 2021 Share Posted January 28, 2021 Are you talking about the internal manifold where all 6 tubes connect? If so, you can remove the plastic outer shell of the Trident to access it and press the tubes back into place. Quote Link to comment Share on other sites More sharing options...
psychofireman Posted January 28, 2021 Author Share Posted January 28, 2021 Yes, I have done that many times but they keep coming off. Was thinking of supergluing them once they were in place Quote Link to comment Share on other sites More sharing options...
Manny Tavan Posted January 28, 2021 Share Posted January 28, 2021 Not a single issue so far...fingers crossed Quote Link to comment Share on other sites More sharing options...
TheClark Posted January 29, 2021 Share Posted January 29, 2021 No issues here so far. I did have a day of 'Test C Fail'. Turned out, when closing the drawer, the tubing was getting pinched. So that is one to watch out for as well. For those not aware... The Trident troubleshooter is quite good at the bottom of this page. https://www.neptunesystems.com/getstarted/trident/troubleshooting/ It had me run the tests with the drawer open, which fixed the problem and confirmed the cause. 1 Quote Link to comment Share on other sites More sharing options...
psychofireman Posted January 29, 2021 Author Share Posted January 29, 2021 My problems have been the 2 clear hoses popping off the black circler thingy. Then, causing a leak Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.